A. Prepare an overhaul before, crime scene equipment failure, the situation, find relevant information, it is best to have a clear plan. 2, held overhaul preparation, organizing personnel, clear maintenance person in charge. 3, the arrangement of security measures, to draw attention to the matter. www.kongyajiyou.net 4, maintenance materials, spare parts and tools ready and in place. Second, an overhaul of the security measures, proper use of tools, labor protection articles 2, confirm the unit has been shut down, no heat, drain and clean the unit within the water, gas. 3, determined to have power, it is best to switch the line after a short up and remove unsafe factor around. 4. downtime hanging signs, someone shoulder. Third, the content and methods of an overhaul, change the oil filter and bearing filter, as follows: (1) the oil filter and bearing filter unscrew and remove from the base. (2) the new compressor oil filter and filter precession bearing on the base and tighten. (3) test to check for leaks. 2, the air filter maintenance, as follows: (1) Remove the air filter cover. (2) Remove the air filter cartridge. (3) Clean the filter and casing pipe inside the dust, dirt Usu compressor air compressor repair parts, such as filters are damaged, crack, should be replaced. (4) Replace the filter, and the back cover. (5) test to check for leaks. Air cleaner air inhaled dust is blocked in the filter, in order to avoid premature wear of the compressor and oil separator is blocked, usually in operation after 1000 hours or one year to replace the filter air compressor In dusty areas, the change interval should be shortened. Filters must be shut down for maintenance, in order to reduce downtime atushi compressor air compressor repair parts, it is recommended to put a new or cleaned filter spare. Clean the filter as follows:. A flat surface in front of a turn tap filter end surfaces to remove most of the heavy and dry Fui Sha. b. Using less than 0.28MPa, dry air along the direction opposite to the intake air blowing, a small nozzle and folded sheets 25 mm apart, along the longitudinal direction thereof, under blowing. c. If there is a grease filter Tacheng compressor compressor repair parts, should be heated in a solvent or without detergent in the wash foam, this filter was immersed in warm water at least 15 minutes, and the clean water hose carry wash, do not use heat to make it speed up the drying method, a filter can be washed five times, then discarded can not be reused. . d put a light inside the filter to be checked, if found thinning, pinholes or damaged shall be abandoned at hutubi compressor air compressor repair parts | Ke Pule compressor (certified) | Compressor science from Xinjiang Le Compressor Limited. Xinjiang Ke Pule Compressor Co., Ltd. (www.xjkant.com) is a leader in Urumqi, Xinjiang, industry-specific equipment, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Ke Pule leadership in the compressor with the staff warmly welcome all inquiries negotiations to create a better future Ke Pule compressor.